When was the final time the roof of one’s building was inspected? If it’s been awhile, the roof could have problems lurking that need immediate attention. Some roof problems cause obvious signs such as for example leaks, while others produce subtle signs that are only detectable at first glance. In either case, leaving the problems unaddressed can cost you thousands when you finally repair them. If the roof on your own building has the commercial roofing long beach problems listed below, an organization that focuses on commercial roofing should repair them quickly:

Buckled Panels

Roof panels buckle due to weather damage and poor installation. Whatever the cause, the buckling allows wind to blow underneath the panels, making them loose. Because the problem worsens, the panels start to fall off, often coming off in large sections when a storm hits. Buckled panels are probably one of the most commonly fixed problems by companies that perform roof repair.

Expended Screw Holes

Expanded screw holes are another problem for panel roofs. Over time, wind and fluctuating temperatures cause the screw holes in panels to widen around the screws that hold the panels set up. This creates a space where water can leak within the panels and soak the roof deck. Once the deck becomes saturated, the problem is costly to fix.

Blistering

Improper heating procedures and dry lapping cause hot bituminous roof systems to blister. Although small blisters seldom pose an issue, large ones can rupture and allow water to seep beneath the bitumen. After the blisters form, warm weather typically makes them worse. Because of the humid subtropical climate in some regions of the country, commercial roofing frequently experiences blistering.

Ponding Water

Blocked drains and improper sloping could cause water to assemble in small ponds on a roof. Repairing a blocked drain is simple, but fixing a sloping problem is more technical. Often, installing a taper insulation system to determine a new slope is the greatest solution. During the rainy season, resolving ponding water is among the most common forms of roof repair.

Loose Flashing

Flashing prevents water from seeping in the crevice where the roof abuts to protrusions such as for example chimneys and vents. As time passes, most flashing must be resealed. If it’s not, leaks could cause serious damage the deck and building interior. Most flashing problems are corrected during the course of scheduled maintenance.

Missing Mortar

Chimneys and high elements of brick walls that have parts of missing mortar could cause leaks. These leaks tend to be mistaken for leaks in the roof membrane, but a thorough inspection by way of a company that specializes in commercial roofing will reveal the real problem. Most sections of missing mortar can be repaired with basic tuck pointing procedures.

Conclusion

The problems above are some of the most common reasons for roof repair. When they are corrected early, most problems are inexpensive to fix, however, not addressing them until they cause serious problems may necessitate roof replacement. Having a scheduled maintenance agreement with a roofing company is best way to ensure problems are detected early.

Leave a Reply

Your email address will not be published. Required fields are marked *